HP ProCurve 5300xl Series User Manual

IP Routing Features
Configuring OSPF
Configuration Rules
■ If the switch is to operate as an ASBR, you must enable redistribution.
When you do that, ASBR capability is automatically enabled.
■ All VLAN interfaces on which you wish to run OSPF must be assigned to
one of the defined areas. When a VLAN interface is assigned to an area,
the primary IP address is automatically included in the assignment. To
include secondary addresses, you must enable OSPF on them separately,
or use the “all” option in the assignment.
OSPF Parameters
You can modify or set the following global and interface OSPF parameters.
Global Parameters:
■ Modify OSPF standard compliance setting.
■ Assign an area.
■ Define an area range.
■ Define the area virtual link.
■ Set global default metric for OSPF.
■ Define redistribution metric type.
■ Enable redistribution.
■ Define redistribution restrict filters.
■ Modify OSPF Traps generated.
Interface Parameters:
■ Assign interfaces to an area.
■ Select the authentication method (simple password or MD5) and the
authentication key for the interface.
■ Modify the cost for a link.
■ Modify the dead interval.
■ Modify the priority of the interface.
■ Modify the retransmit interval for the interface.
■ Modify the transit delay of the interface.
11-39

HP ProCurve 5300xl Series Specifications

General

Brand	HP
Model	ProCurve 5300xl Series
Category	Switch
Language	English