IP Routing Features
Configuring RIP
The information in this display includes the following fields, which are defined
under ““RIP Interface Information” on page 11-29: IP Address, Status, Send
mode, Recv mode, Metric, and Auth.
The information also includes the following fields:
■ Bad packets received – The number of packets that were received on
this interface and were not processed for any reason.
■ Bad routes received – The number of route entries that were received
on this interface and were not processed for any reason.
■ Sent updates – The number of RIP routing updates that have been sent
on this interface.
Displaying RIP interface information by IP Address: For example, to
show the RIP interface information for the interface with IP address 100.2.0.1,
enter the show ip rip interface command as shown below:
Figure 11-4. Example of Show IP RIP Interface Output by IP Address
The information shown in this display has the same fields as for the display
for a specific VLAN ID. See the previous page for the definitions of these fields.
Syntax: show ip rip interface [ip-addr | vlan < vlan-id >]
Displaying RIP Peer Information
To display RIP peer information, enter the show ip rip peer command at any
context level.
11-31
To Next Page
Loading...
Need help?
General