Access Control Lists (ACLs) for the Series 3400cl and Series 6400cl Switches
Configuring and Assigning an ACL
< any | host < src-ip-addr > | ip-addr/mask -length >
In an extended ACL, this parameter defines the source IP
address (SA) that a packet must carry in order to have a
match with the ACE.
•
•
•
any — Specifies all inbound IP packets.
host < src-ip-addr > — Specifies only inbound packets from
a single IP address. Use this option when you want to
match only the IP packets from one source IP address
(device).
src-ip-addr/mask-length — Performs the specified action
on any IP packet having a source address within the
range defined by either
< src-ip-addr / cidr-mask-bits >
or
< src-ip-addr < mask >>
Use this criterion to filter packets received from either a
subnet or a group of IP addresses. The mask can be in
either dotted-decimal format or CIDR format with the
number of significant bits. Refer to
“Using CIDR
Notation To Enter the ACL Mask” on page 10-42.
The mask is applied to the IP addressin the ACL to define
which bits in a packet’s source IP address must exactly
match the IP address configured in the ACL and which
bits need not match. Note that specifying a group of
contiguous IP addresses may require more than one
ACE. For more on how masks operate in ACLs, refer to
“How an ACE Uses a Mask To Screen Packets for Matches”
on page 10-30.
[operator < src-port tcp/udp-id >]
In an extended ACL where you have selected either tcp or
udp as the packet protocol type (see above), you can option-
ally use a TCP or UDP source port number or range of
numbers to further define the criteria for a match. To
specify a TCP or UDP port number, (1) select the eq com
parison operator and (2) enter the port number or a well-
known port name.
10-50
To Next Page
Loading...
Need help?
General