HP ProCurve Wireless Access Point 530 User Manual

2-5
Installing the Access Point 530
Installation Procedures
Installing the
Access Point 530
2. Verify the Access Point Completes Initialization
Before mounting the access point in its network location, you should first
verify that it is working properly by plugging it into a power source, or
connecting it to a switch that provides Power over Ethernet, and verifying that
it completes its system initialization.
1. Connect a network cable from a PoE source device (such as a switch) to
the RJ-45 port on the back of the access point, or connect the supplied
power adapter to the power connector on the back of the access point,
and then into a properly grounded electrical outlet.
Note The Access Point 530 does not have a power switch. It is powered on when
the power adapter is connected to the access point and to a power source, or
when a network cable is connected to the access point and to a network device
that provides Power over Ethernet. For safety, when connecting to an elec-
trical outlet, the power outlet should be located near the access point.
Use only the AC power adapter supplied with the access point. Use of other
adapters, including adapters that came with other ProCurve Networking
products, may result in damage to the equipment.
Or connect power adapter
to the power connector
Connect network
cable to PoE switch

HP ProCurve Wireless Access Point 530 Specifications

General

Brand	HP
Model	ProCurve Wireless Access Point 530
Category	Wireless Access Point
Language	English