HP ProCurve Wireless Access Point 530 User Manual

3-9
Getting Started With Access Point Configuration
Getting Started With Access
Point Configuration
Where to Go From Here
The above procedure, using the CLI, configured your access point with a
Manager password, IP address, and subnet mask. As a result, with the proper
network connections, you can now manage the access point from a PC
equipped with Telnet or a Secure Shell client, or a Web browser interface. The
above procedure also configured the primary Service Set Identifier (SSID),
the radio channel, and enabled wireless operation. Your wireless stations can
now access the network by setting their SSID and radio channel to the same
values used by the access point. Note that some wireless stations can be
configured to scan all of the radio channels for an access point and the SSID.
Some basic information on managing your access point is included in the next
section. For more information on the console and Web browser interfaces,
and all the features that can be configured on the Access Point 530, please see
the Management and Configuration Guide.
To Recover from a Lost Manager Password: If you cannot start a con-
sole session because of a lost manager password, you can reset the password
to the factory default by getting physical access to the access point and
pressing and holding the Clear button for more than one second.

HP ProCurve Wireless Access Point 530 Specifications

General

Brand	HP
Model	ProCurve Wireless Access Point 530
Category	Wireless Access Point
Language	English