HP ProCurve Wireless Access Point 530 User Manual

4-5
Using an External Antenna with the Access Point 530
Installation Procedures
Using an External Antenna
with the Access Point 530
Note that diversity antennas have two pigtail cables. A diversity antenna
includes two internal antenna elements that are identical. Both antenna pigtail
cables must be connected to the access point for correct operation.
Other non-diversity antennas, which have only one pigtail cable, attach to the
access point’s “Primary” antenna connector for the appropriate radio.
To connect pigtail cables to the access point, follow these steps:
1. Disable the access point radio using the Web browser interface, CLI, or
SNMP.
2. Remove power to the access point.
3. Remove the connector cover on the back of the access point.
4. For diversity antennas, connect the antenna pigtail cables to the exposed
Reverse SMA connectors for the appropriate radio.
For non-diversity antennas, be sure to connect the single pigtail cable to
the Reverse SMA connector labeled “Primary.”
Caution Do not over-torque the antenna cables on SMA connector. (8 in-lb max).
5. Reconnect power to the access point.
Note Before enabling the radio with an external antenna attached, be sure to first
configure the access point’s antenna mode and type.
2.4 GHz or 5
GHz Antenna
(802.11a/b/g)
Primary Primary
2.4 GHz Antenna
only
(802.11b/g)
21
Antenna pigtail cable
Screw onto access point’s
Reverse SMA connector

HP ProCurve Wireless Access Point 530 Specifications

General

Brand	HP
Model	ProCurve Wireless Access Point 530
Category	Wireless Access Point
Language	English