HP ProLiant ML110 User Manual

C
Power Cord Set Requirements
The power cord set meets the requirements for use in the country where you purchased your
equipment. The voltage selection switch allows you to select the appropriate line voltage for
your server.
Power cord sets for use in other countries must meet the requirements of the country where
you use the server. For more information on power cord set requirements, contact your
authorized HP dealer.
General Requirements
The requirements listed below are applicable to all countries:
•
•
•
•
The length of the power cord must be at least 1.8 m (6.0 ft) and a maximum of 3.7 m
(12 ft).
The power cord set must be approved by an acceptable accredited agency responsible for
evaluation in the country where the power cord will be used.
The power cord set must have a minimum current capacity and nominal voltage rating of
10 A/125 volts AC, or 10A/250 volts AC, as required by the power system of each
country.
The appliance coupler must meet the mechanical configuration of an EN60320/IEC 320
Standard Sheet C13 Connector, for mating with the appliance outlet on the server.
HP ProLiant ML110 Server Operations and Maintenance Guide C-1

HP ProLiant ML110 Specifications

General

Brand	HP
Model	ProLiant ML110
Category	Server
Language	English