HP ProLiant ML110 User Manual

System Setup
Powering On/Off the Server
To Apply Power to the Server
After making sure that you have set up the server properly and connected all the required
peripheral cables, you can now apply power to the server.
1. Verify that the monitor is properly connected to the server and is plugged into a properly
grounded, wall power outlet.
2. Connect the server’s power cable.
Plug the power cable into the power cable socket located on the rear panel of the server.
Then plug the other end of the power cable into a properly grounded, wall power outlet.
Figure 3-6: Connecting the server’s power cable
3. Press the power button on the front panel and then turn on the monitor.
Figure 3-7: Turning on the server
3-6 HP ProLiant ML110 Server Operations and Maintenance Guide

HP ProLiant ML110 Specifications

General

Brand	HP
Model	ProLiant ML110
Category	Server
Language	English