HP ProLiant ML110 User Manual

BIOS Setup Utility
To View the System Summary Screen
You first need to enable the display of the System Summary Screen during bootup. Follow
the steps below.
1. In the Main
menu screen, select Boot Features.
The Boot Features submenu is displayed.
2. Select Summary Screen.
3. Press the plus (+) or minus (-) key to set the parameter to Enabled.
4. Press F10 to save the changes you made and close the Setup Utility.
5. Reboot the server.
The System Summary Screen is displayed briefly at the end of POST.
Figure 5-2: System Summary Screen
6. Press the Pause/Break key to continue displaying the screen until another key is pressed.
7. Press any key to continue with the system bootup.
System Passwords
The Security menu lets you set system passwords that would provide different levels of
protection for the server. There are three types of passwords that you can set:
• Supervisor password
Entering this password will allow the user to access and change all settings in the Setup
Utility.
HP ProLiant ML110 Server Operations and Maintenance Guide 5-5

HP ProLiant ML110 Specifications

General

Product Line	ProLiant
Server Type	Tower
Processor	Intel Xeon E3-1200 series
Chipset	Intel C202
Memory Slots	4
Storage	SATA Hard Drives (HDDs) or Solid State Drives (SSDs)
Drive Bays	4 LFF or 8 SFF
RAID Support	RAID 0, 1, 10
Form Factor	Tower
Management	HP iLO
Operating System Support	Windows Server, Linux, VMware
Memory	DDR3 or DDR4 ECC Unbuffered DIMMs (UDIMMs) (depending on the specific generation)