Touch Screen
Touch Screen allows you to operate the thin client by touching the display screen.
To enable the touch screen:
1. Double-click Touch Screen and select
2. Select Enable Touch Screen.
3. Select the Controller Type and Device Port, and elect to Swap X or Swap Y, if desired.
4. Click OK to save your changes and close the dialog box.
A message appears to inform you that your changes will take effect at the next login.
5. Click Yes to log off and restart the desktop with your changes.
If you click No, the current desktop environment will remain unchanged.
6. Click Control Panel > Peripherals > Touch Screen and click Calibrate to calibrate the touch
screen.
NOTE: The touch screen can only be calibrated if it has been enabled and the desktop
restarted.
The touch screen will not track correctly on the screen if the display is rotated.
USB Manager
To set USB mounting preferences:
1. Double-click USB Manager.
2. Select one of the following remote protocols:
● Citrix
●
Local
●
RDP
●
RGS
●
VMware View
●
vWorkspace
3. If the setting is Local, you can also specify: allow devices to be mounted and mount devices
read-only.
4. Click OK to save your preference and close the dialog box.
Setup
These utilities enable you to set up the thin client to your requirements. The following utilities are
available on the Setup tab:
●
Date and Time on page 39
●
Global Network Settings on page 39
38 Chapter 3 Reference ENWW
To Next Page
Loading...
Need help?
General