Deploy HP ThinPro Image from a Bootable USB Flash Drive
To install an HP ThinPro image from a bootable USB flash drive:
1. Turn off the target thin client.
2. Insert the bootable USB flash drive.
3. Turn on the thin client.
NOTE: If you are using a t5325 you must press and release the power button again to boot
from the USB key device.
The screen remains black for 10-15 seconds while the thin client detects and boots from the
bootable USB flash drive.
NOTE: If the thin client fails to boot from the USB flash drive, try unplugging all other USB devices
and repeat the procedure.
Manage the HP ThinPro Configuration
The HP ThinPro configuration file contains the connections set and the settings set through the
Control Panel applications. A configuration file is specific to a given version of HP ThinPro. Be sure to
use a configuration file generated with the same version of HP ThinPro.
HP ThinPro allows you to:
●
Save the HP ThinPro Configuration on an FTP Server on page 52
●
Restore an HP ThinPro Configuration From a Remote Server on page 52
●
Capture an HP ThinPro Configuration to a USB Drive on page 53
●
Restore an HP ThinPro Configuration From a USB Key on page 53
Save the HP ThinPro Configuration on an FTP Server
1. Double-click ThinState.
2. Select the HP ThinPro configuration, and then click Next.
3. Select save the configuration, and then click Next.
4. Click on an FTP server, and then click Next.
NOTE: The file path must exist on the FTP server before you can make the copy. ThinState
produces an error if the file path does not exist on the FTP server.
5. Type the FTP server information in the fields, and click Finish.
The HP ThinPro configuration capture is complete.
Restore an HP ThinPro Configuration From a Remote Server
1. Double-click ThinState.
2. Select the HP ThinPro configuration, and then click Next.
3. Select restore a configuration, and then click Next.
4. Click on a remote server, and then click Next.
52 Chapter 3 Reference ENWW
To Next Page
Loading...
Need help?
General