FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
Indicators
Table 3-39 describes the indicators on the ECC800 monitoring module.
Table 3-39 Indicators on the ECC800 monitoring module
The power supply is normal, the
program is being loaded, or
WiFi WPS is pairing.
The power supply is abnormal.
Blinking at
long
intervals
The software runs properly (the
indicator blinks at 0.5 Hz, on for
1s and then off for 1s) or the
ECC800 registers with the
NetEco successfully.
Blinking at
short
intervals
The ECC800 does not register
with the NetEco (the indicator
blinks at 4 Hz, on for 0.125s and
then off for 0.125s).
A system failure alarm is
generated.
The 3G module is powered on.
The 3G module stops running,
or no 3G module is configured.
Blinking at
long
intervals
The 3G module succeeds in
dial-up (the indicator blinks at
0.5 Hz, on for 1s and then off
for 1s).
Blinking at
short
intervals
The 3G module registers with
the operator network
successfully (the indicator
blinks at 4 Hz, on for 0.125s and
then off for 0.125s).
Communication
status indicator
No network parameters exist, or
a network is to be created.
Blinking at
long
intervals
A network is set up, and no
node access is allowed (the
indicator blinks at 0.5 Hz, on for
1s and then off for 1s).
To Next Page
Loading...
Need help?
General
