2 Configuring the IPMI Settings
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
1
2
Configuring the IPMI Settings
With the Nuvoton WPCM450 BMC Controller and the IPMIView firmware built in, the
motherboards allow the user to access, monitor, manage and interface with multiple systems
in various remote locations. This section provides detailed information on how to configure
the IPMI settings.
2.1 Configuring BIOS
Before configuring IPMI, follow the instructions below to configure the system BIOS settings.
Enabling COM Port for SOL (IPMI)
Step 1 Press the Del key at bootup to enter the BIOS Setup Utility.
Step 2 Select Advanced and press Enter to enter the Advanced menu.
Step 3 From the Advanced menu, select Remote Access and press Enter.
Step 4 Make sure that the COM port for SOL (COM2 or COM3) is enabled (marked with "*"). If not,
Select the port for SOL and press Enabled, See Figure 2-1. (For IPMI to work properly,
BIOS will set the console redirection on this port by default.).
----End
User Guide
Issue 04 (2014-09-15)
RH2488 V2 BMC
To Next Page
Loading...
Need help?
General