Connecting to Hydrawise
Controller has connected to the internet and is now
connecting to the Hydrawise servers
OK - subscribing to updates
Controller has connected to Hydrawise and is getting its
configuration
OK - processing cloud update
Controller is connected to Hydrawise and is processing a
configuration change
Updating Wi-Fi firmware
The controller is updating the Wi-Fi firmware to
19.5.4. During this period no configuration changes will
be processed by the controller.
Updating Pro-C adapter
The controller is updating the Pro-C adapter software.
During this period no configuration changes will be
processed by the controller.
Success
Success percentage - this is the percentage of time the controller has been connected to
Hydrawise. We measure this over a 6-hour time frame. 100% means it was always
connected, 80% means that for 20% of the time it was not connected.
A low success percentage will indicate a poor wireless connection between the controller
and your access point.
To improve your wireless signal strength you could try the following –
Move the controller closer to your wireless router.
Remove any obstacles in a direct line of sight between the controller and your wireless
router such as metal items (metal is an extremely good isolator for WiFi signals).
Move your wireless router closer to the controller.
Install a higher gain antenna on your wireless router.
Use Ethernet to a location closer to the controller and install a new wireless router.
Consider a WiFi repeater/extender between your wireless router and the Hydrawise
controller to boost the signal strength.
Consider moving the controller away from potential sources of interference, including
microwave ovens, nearby base stations using adjacent channels or cordless
To Next Page
Loading...
Need help?
General
