ENG
Setting Watering Days
1. Press the
button until the icon is displayed.
2. The program letter (A, B, or C) will be displayed.
3. Arrows point at the specic days of the week in which watering
will occur. Press the or buttons to scroll though the days.
4. Press the
button to activate that day for the program displayed,
or the button to cancel watering for that day. The arrow will
show on the watering days for the active program.
5. Press the
button to set days to water for a different
program, if desired.
6. Press the
button to proceed to the next programming
function or allow controller to return to idle mode.
Selecting Odd/Even Days to Water
This feature uses numbered days of the month for watering instead
of specic days of the week.
1. Press the button until the icon is displayed.
2. Press the
button until the cursor is above either ODD or
EVEN on the display.
3. Press the button to select, or the button to cancel either
ODD or EVEN days to water.
4. Once ODD or EVEN mode is activated it will be the only cursor
shown on the display.
Selecting Interval Days to Water
1. Press the
button until the icon is displayed.
2. Press the
button until the cursor is above INT on the display.
3. Press the
button and a 1 will be ashing indicating the
number of days between watering.
4. Press the
or button to select the number of days
between watering days (1 to 31).
Setting the Seasonal Adjustment
1. Press the
button until the is displayed.
2. Press the
or button to increase or decrease the seasonal
adjustment value from the default 100% (down to a minimum
of 10% or a maximum of 150%).
3. The value programmed for seasonal adjustment will be applied
to all irrigation programs and will immediately be reected in
PROGRAMMING (CONTINUED)
O
INT
9
To Next Page
Loading...
Need help?
General
