ENG
To Install the Battery/Batteries
1. Unscrew the rear body of the NODE body to gain access to
the battery compartment.
2. Insert the battery/batteries into the battery tray and connect to
the controller using the battery connector.
3. Make sure that no water is inside the battery compartment.
4. Screw the NODE rear body back onto the front half.
NOTE: Make sure that the seal marker on the
rear half of the NODE lines up with the front
half, ensuring that a proper seal is created.
The NODE uses two standard 9-volt batteries (not included) to
operate the valves and program the controller. The controller can
operate using either a single 9-volt battery or using two 9-volt
batteries. Under normal conditions, the expected life is 1 year for a
single battery and two years when using two 9-volt batteries.
NOTE: The NODE has non-volatile memory
which allows for the battery to be removed
without losing program information.
CONNECTING THE BATTERY/BATTERIES
4
To Next Page
Loading...
Need help?
General
