ENG
IDLE MODE
RUN MODE
Normally the NODE display shows the time and day, day of the
week, MV (if master valve option is activated) and the battery life
indicator. During a short period of inactivity the display will shut off
to retain battery power. Pressing any button will wake up the NODE
to the Idle Mode.
When the controller is operating a program the items shown on the
display will include the station number, program letter, remaining
runtime, and the blinking Rotor icon.
The NODE uses standard Hunter controller programming with 3
programs (A, B, C) and 4 start times per program. On standard
Hunter controllers a dial is used to scroll between the programming
functions, however, on the NODE the button is used to quickly
and easily create the irrigation program. When programming, the
ashing portion of the display can be changed by pressing the
or buttons. To change something that is not ashing, press the
or buttons until the desired item is ashing.
Setting the Date and Time
1. Push the
button until the icon is displayed.
2. All 4 digits will be displayed representing the year. Use the
or buttons to change the year. Press the button to
proceed to setting the month.
3. All 4 digits will be displayed with the two digits on the left
representing the month ashing. Use the
or buttons to
change the month. Press the button to proceed to setting
the day.
4. Only the two digits on the right side will be displayed and
ashing, representing the day. Press the
or button to
change the day. Press the button to proceed with changing
the hour. Press the button to proceed to setting the time.
5. The AM/PM/24 time setting is shown ashing. Press the or
button to change the time setting to AM, PM, or 24-hour
time. Press the button to proceed to setting the hour.
PROGRAMMING
7
To Next Page
Loading...
Need help?
General
