ENG
the run times displayed. Example, if 20 minute run times are
programmed and then the seasonal adjustment is changed
from 100% to 50%, the run times displayed will be 10 minutes.
Turning the System Off
To turn your controller off, press the
button until the icon
and Off is displayed on screen. To return the controller to auto
programming mode, press the button. The controller will
immediately return to auto programming mode and will display the
time and battery life indicator.
Manual Watering
Manual Watering allows the user to test each station or a program
for a specied run time. The weather sensor condition (if used) will
be disregarded in this mode.
1. Make sure the controller is in Idle Mode. Press and hold the
button until the icon is displayed.
2. The station number will be displayed in the lower left side of
the display along with the run time.
3. Use the
and buttons to select the desired station and
the and buttons to set the manual watering time for the
station shown.
4. To manually activate a program, press the
button. The
program letter (A, B, or C) will show on the screen. If a different
program is needed, press the button until the desired
program is displayed.
5. To stop the Manual watering cycle press the
button until
the time is reduced to zero.
6. Press the
button to proceed to the next programming
function or allow controller to return to idle mode.
NOTE:
• Pressing the
or buttons when a station
in running in manual watering will modify the
irrigation time for that station.
• Pressing the
button when a station is running
in manual watering will stop irrigation on the
current station and advance to the next station.
• Pressing the
button when a station is running
in manual watering will stop the irrigation on the
current station and revert to the previous station.
PROGRAMMING (CONTINUED)
10
To Next Page
Loading...
Need help?
General
