26
8. System Settings
The Smartsigns Compact 300 Series provides multiple working modes for its users
• Measurement mode – Take measurements
• Review mode – View saved measurements
• Parameter setting mode – Set pulse tone ON or OFF
• Maintenance mode – Adjust system settings
• Standby mode - Sleep
Each mode offers different facilities and access to different settings.
8.1 Measuring Mode
After the initial startup, the system defaults to the measurement mode.
From here the user can undertake a series of measurements.
1. Press
to start the NIBP measurement.
2. Apply the SpO2 sensor to the patient, after a short period, the SpO2 measurement
will be displayed on the screen.
3. Apply a new infrared lens cover to the tip of the Thermometer, temperature
measurements can now be made
4. After making a measurement, data will be displayed in the corresponding area on the
display.
5. Press
to save the measurement to memory.
6. After measuring one or multiple parameters, data will be automatically saved if there
is no additional measurement made within 2 minutes.
8.2 Review Mode
In the measuring mode, press for 2s to enter review mode; in this mode, up to 50
sets measurement data can be reviewed. Measurements are stored in date and time
order.
1. Press
to cycle through the stored measurements, the oldest measurement
will be displayed fi rst.
2. Press
to return to the measurement mode.
This monitor saves up to 50 measurements.
System Settings
To Next Page
Loading...
General