Note: The Bluetooth
®
pairing mode is on for
3 minutes. If the product does not pair with
Bluetooth
®
in 3 minutes, switch off the
product. Wait until the LED status indicator
is not lit, and then switch on the product
again.
2. Enter the factory PIN code.
3. Log on to your Husqvarna account in the
Automower
®
Connect app to pair your
product with Automower
®
Connect.
Note: It is recommended to pair your product
with Automower
®
Connect to get access to
all functions in the product. If it is not
necessary to pair your product with
Automower
®
Connect, push the
arrow
symbol to continue to the menu.
4. Start Bluetooth
®
on your mobile device.
5. Select
My mowers
in the Automower
®
Connect app, and then select the plus sign
(+).
6. Select model. The Automower
®
Connect
app searches for available products within
short-range (Bluetooth
®
).
7. Select product.
8. Obey the instructions in the Automower
®
Connect app.
3.12 Settings in Automower
®
Connect
The product has factory settings but
the settings can be adapted to each
work area.
3.12.1 Schedule
In
Schedule
you can change the
schedule settings for the product. To
change the settings, obey the
instructions in the Automower
®
Connect app.
The schedule function controls which work hours
the product should operate and not operate.
When the product is not operating it is parked in
the charging station. The operating hours and
days can be seen in an overview in the
Automower
®
Connect app.
The default schedule setting allows the product to
operate around the clock 7 days a week. This is
normally a suitable setting for a work area
corresponding to the maximum capacity. If the
work area is less than the maximum capacity the
schedule should be used to minimize wear on the
grass and to the product.
To calculate the schedule setting, refer to
To
calculate the schedule setting on page 31
.
3.12.1.1 To edit the schedule settings
1. Select
Settings > Schedule > Edit
in the app.
2. Select the pencil symbol in the app.
3. Select which days of the week and hours the
product must operate.
4. Select
Save
.
3.12.1.2 To add a new schedule setting
1. Select
Settings > Schedule > Edit
in the app.
2. Select the plus sign in the app.
3. Select which days of the week and hours the
product must operate.
4. Select
Save
.
3.12.1.3 To calculate the schedule setting
1. Calculate the dimension of your lawn in m
2
/
yd
2
.
2. Divide the m
2
/ yd
2
of the lawn with the
approximate operation capacity. Refer to
table below.
3. The result is equal to the number of hours
that the product must operate each day.
Note:
The operation capacity is approximate and
is calculated for flat and open work area. If the
work area has a lot of slopes or obstacles, you
need to increase the
Schedule
settings.
Model Approximate operation ca-
pacity, m
2
/ yd
2
/ h
Automower
®
435X AWD
146 / 175
Example: A lawn of 500 m
2
/ 600 yd
2
, cut with an
Automower
®
435X AWD.
500 m
2
/ 146 ≈ 3.5 h.
600 yd
2
/ 175 ≈ 3.5 h.
1404 - 002 -
Installation - 31
To Next Page
Loading...
Need help?
General
