4. Make sure that the blade disc can rotate
freely.
5. Make sure that the blades are not damaged
and can pivot freely.
5.2.2 Chassis
Clean the underside of the chassis. Brush or
wipe with a damp cloth.
5.2.3 Wheels
Clean around the wheels. Grass on the wheels
can impact on how the product performs in
slopes.
5.2.4 The body of the product
Use a moist, soft sponge or cloth to clean the
body of the product. If the body of the product is
dirty, use a mild soap solution to clean it.
5.2.5 Charging station
WARNING: Use the plug to disconnect
the charging station before any
maintenance, or cleaning of charging
station or power supply.
Clean the charging station regularly from grass,
leaves, twigs and other objects that may impede
docking.
5.3 Replace the blades
WARNING:
Use blades and screws of
the right type. Husqvarna can only
guarantee safety when using original
blades. Only replacing the blades and
reusing the screw can result in a screw
wearing during mowing. The blades
can then be propelled from under the
body and cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the best
mowing result and low energy usage. All 3 blades
and screws must be replaced at the same time to
obtain a balanced cutting system. Use
Husqvarna original blades embossed with the
crowned H-mark logotype, refer to
Warranty
terms on page 65
.
5.3.1 To replace the blades
1. Switch off the product. Refer to
To switch off
the product on page 38
.
2. Put on protective gloves.
3. Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body.
4. Rotate the skid plate so that its holes align
with the screws for the blade.
1404 - 002 -
Maintenance - 41
To Next Page
Loading...
Need help?
General
