Husqvarna AUTOMOWER 435X AWD User Manual

Error icon Description Action
The product has stopped because of
low battery.
Refer to the error message "Empty Bat-
tery" in Fault messages on page 47 .
The product has stopped because of a
blockage to the cutting system.
Examine the blade disc and its adja-
cent area. Remove grass or other ob-
jects that can cause blockage to the
cutting system.
The product has stopped because of a
temporary electronic or firmware prob-
lem.
Switch off/on the product. If the prob-
lem continues, contact your local Husq-
varna representative.
The product has stopped because of
an activated alarm.
Restart the product. The settings for
the alarm are in the security menu in
Automower
®
Connect app.
The product has stopped because of
the wrong PIN code.
Enter the correct PIN code. If the PIN
code is forgotten, use the link in the
app to send to PIN code to your regis-
trated e-mail adress. If you have not
registrated the e-mail adress contact
your local Husqvarna representative.
6.3 Fault messages
The table below shows a number of fault messages that may be shown in Automower
®
Connect. Some
of the errors can be confirmed in the Automower
®
Connect and some the message needs to be
1404 - 002 - Troubleshooting - 47

Husqvarna AUTOMOWER 435X AWD Specifications

General

Cutting Width	22 cm
Cutting Height, Min-Max	30-70 mm
Battery Type	Li-Ion
Typical Charging Time	30 min
Typical Mow Time on One Charge	100 min
Product Size, LxWxH	93x55x29 cm
Maximum Slope Performance Inside Installation	70%
Working Area Capacity	3500 m²
Battery Voltage	18 V
Battery Capacity	5.0 Ah
Guide Wire	Yes
GPS-assisted Navigation	Yes
Lift Sensor	Yes
Tilt Sensor	Yes
Ultrasonic Sensor	Yes
Connectivity	Bluetooth, Cellular
Weather Resistance	Yes
Warranty	2 years
Blade Type	Pivoting Razor Blades