18 SERVICE WORK ON THE ENGINE 103
F00438-10
Main work
– Check the engine oil level.
Info
After switching off the engine, wait one minute before checking the level.
The engine oil is at a level between the lower edge
and the middle
of
the level viewer.
»
If the engine oil is not up to the lower edge
of the level viewer:
– Add engine oil. ( p. 105)
18.3 Changing the engine oil and oil filter, cleaning the oil screens
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
– Wear suitable protective clothing and safety gloves.
– In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Drain engine oil with engine at operating temperature.
Preparatory work
– Remove the engine guard. ( p. 70)
– Park the motorcycle on a level surface.
F00441-10
Main work
– Place a suitable container under the engine.
–
Remove oil drain plug
with the magnet and seal ring.
F00442-10
–
Remove screw plug
with the short oil screen and the O-rings.
Info
Do not remove screw
.
F00443-10
–
Remove screw plug
with the long oil screen
and the O-rings.
– Completely drain the engine oil.
– Thoroughly clean the parts and sealing surfaces.
To Next Page
Loading...
Need help?
General
