EasyManuals Logo
Home>Husqvarna>Motorcycle>FE 450

Husqvarna FE 450 User Manual

Husqvarna FE 450
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
12 SERVICE WORK ON THE CHASSIS 60
M00435-10
Main work
Remove all screws on the main silencer.
Take off silencer cap
and O-ring
.
Take off outer tube
and O-ring
.
Remove glass fiber yarn filling
from inner tube
.
Clean the parts that need to be reinstalled and check for damage.
Fit the new glass fiber yarn filling onto the inner tube.
Mount O-ring
onto connecting cap
.
Position the inner tube with the connecting cap and glass fiber yarn filling in the
outer tube.
Mount O-ring
on the silencer cap.
Position the silencer cap with O-ring
in the outer tube.
Mount and tighten all of the screws.
Guideline
Screws on the main silencer M5 7 Nm (5.2 lbf ft)
Finishing work
Install the main silencer. ( p. 59)
Install the right side cover. ( p. 58)
12.31 Removing the fuel tank
Danger
Fire hazardFuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
Do not refuel the vehicle in the vicinity of open flames or lit cigarettes.
Switch off the engine for refueling.
Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
If any fuel is spilled, wipe it off immediately.
Observe the specifications for refueling.
Warning
Danger of poisoningFuel is poisonous and a health hazard.
Avoid skin, eye and clothing contact with fuel.
Immediately consult a doctor if you swallow fuel.
Do not inhale fuel vapors.
In case of skin contact, rinse the affected area with plenty of water.
Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
Change your clothing in case of fuel spills on them.
Keep fuels correctly in a suitable canister, and out of the reach of children.
Preparatory work
Remove the air filter box cover. ( p. 56)
Remove the seat. ( p. 55)
K00596-10
Main work
Unplug connector
of the fuel pump.
Clean plug-in connection
of the fuel line thoroughly with compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve!

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Husqvarna FE 450 and is the answer not in the manual?

Husqvarna FE 450 Specifications

General IconGeneral
BrandHusqvarna
ModelFE 450
CategoryMotorcycle
LanguageEnglish

Related product manuals