14 WHEELS, TIRES 80
14.1 Removing the front wheel
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 45)
F00335-10
Main work
– Press the brake caliper onto the brake disc by hand in order to push back the
brake pistons.
Info
Make sure that you do not press the brake caliper against the spokes
when pushing back the brake pistons.
F00313-10
–
Loosen screw
by several rotations.
–
Loosen screws
.
–
Press on screw
to push the wheel spindle out of the axle clamp.
–
Remove screw
.
F00337-10
Warning
Danger of accidents Damaged brake discs reduce the braking effect.
– Always lay the wheel down in such a way that the brake disc is not
damaged.
– Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
Info
Do not pull the hand brake lever when the front wheel is removed.
H00934-10
–
Remove spacers
.
14.2 Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
– Always keep the brake discs free of oil and grease.
– Clean the brake discs with brake cleaner when necessary.
H00935-10
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change the front wheel bearing.
–
Clean and grease shaft seal rings
and contact surface
of the spacers.
Long-life grease ( p. 118)
To Next Page
Loading...
Need help?
General
