Husqvarna FE 450 User Manual

12 SERVICE WORK ON THE CHASSIS 48
F00277-10
Main work
– Open the cable holder in front of the right radiator and detach the wiring harness.
–
Remove screws

and hang the voltage regulator to the side.
– Open the cable holder in front of the left radiator and detach the wiring harness.
F00279-10
–
Remove screw

.
–
Remove screw

.
– Take off the upper triple clamp with the handlebar and set it aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
F00278-10
–
Remove O-ring

and protective ring

.
– Take off the lower triple clamp with the steering stem.
– Remove the upper steering head bearing.
12.10 Installing the lower triple clamp
0
0
11
0
0
22
0
0
33
B01632-10
Main work
– Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease ( p. 118)
– Position the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether upper steering head seal

is correctly positioned.
–
Mount protective ring

and O-ring

.
F00279-11
– Position the upper triple clamp with the handlebar.
–
Mount screw

but do not tighten yet.

Husqvarna FE 450 Specifications

General

Brand	Husqvarna
Model	FE 450
Category	Motorcycle
Language	English