3-8 MAX200 Instruction Manual
1-97
SETUP
220/380/400/415V Transformer T1 and T2 Configurations
• The 220/380/400/415 volt, 3 PH, 50 Hz power supply is shipped from the factory set up for 380-volt
operation, unless otherwise specified. To change the power supply to a different voltage the control
transformer T1 and 30 kw transformer T2 must be reconfigured (see Figure 3-2).
WARNING
Danger: High Voltage. Always disconnect input power at the line disconnect switch before
servicing.
* A long # 6 wire is shipped with every unit.
Figure 3-2 220/380/400/415V Transformer T1 and T2 Configurations (1 of 2)
When changing the voltage for 220-volt operation,
the line fuses F1 and F2 must also be changed from
7.5A to 20A. The alternate fuses are located on the
floor of the power supply.
To Next Page
Loading...
Need help?
General
