Hypertherm Powermax 85 Operator's Manual

SPECIFICATIONS
1-12 powermax 65/85 Operator Manual
Powermax65 cutting specifications
Handheld cut capacity (material thickness)
Recommended cut capacity at 20 ipm (500 mm/min) 3/4 in (19 mm)
Recommended cut capacity at 10 ipm (250 mm/min) 1 in (25 mm)
Severance capacity at 5 ipm (125 mm/min) 1-1/4 in (32 mm)
Mechanized pierce capacity (material thickness)
Pierce capacity (for edge starts, the capacities are the
same as the handheld capacities)
1/2 in (12 mm)
Maximum cut speed* (mild steel)
1/4 in (6 mm) 145 ipm (4000 mm/min)
1/2 in (12 mm) 50 ipm (1400 mm/min)
3/4 in (19 mm) 24 ipm (600 mm/min)
1 in (25 mm) 12 ipm (320 mm/min)
Gouging capacity
Metal removal rate on mild steel 10.7 lbs/hr (4.8 kg/hr)
Duramax series torch weights (refer to “Component weights” on page 1-5)
Duty cycle and voltage information (refer to “Powermax65 power supply ratings” on
page 1-6)
* Maximum cut speeds are the results of Hypertherm’s laboratory testing. Actual cutting speeds
may vary based on different cutting applications.

Hypertherm Powermax 85 Specifications

General

Brand	Hypertherm
Model	Powermax 85
Category	Welding System
Language	English