Hypertherm Powermax 85 Operator's Manual

TORCH SETUP
powermax 65/85 Operator Manual 3-9
Converting an M65/M85 torch to an M65m/M85m torch
You can convert a full-length machine torch to a mini-machine torch by removing the positioning
sleeve.
ote:N If you are converting a full-length machine torch to a mini-machine torch and mounting
the torch at the same time, skip this section and follow the instructions in “Mount the
torch” on page 3-11.
Refer to the figures in the section “Machine torch setup” on page 3-8 and follow these instructions.
ote:N While disconnecting and reconnecting the torch parts, maintain the same orientation
between the torch head and torch lead. Twisting the torch head in relation to the torch
lead can cause damage.
1. Disconnect the torch lead from the power supply and remove the consumables from the torch.
2. Unscrew the strain relief body from the strain relief nut and slide the strain relief body back
along the torch lead.
3. Unscrew the strain relief nut from the positioning sleeve and slide the nut back along the torch
lead.
4. Unscrew the positioning sleeve from the coupler.
5. Unscrew the coupler from the mounting sleeve.
6. Remove the three screws from the consumables end of the mounting sleeve and slide the
mounting sleeve off the front of the torch body.

Hypertherm Powermax 85 Specifications

General

Brand	Hypertherm
Model	Powermax 85
Category	Welding System
Language	English