Hypertherm Powermax125 User Manual

42 Powermax125 Operator Manual 808080 Revision 0
3 – Basic System Operations
Operating the Powermax
Follow the steps below to begin cutting or gouging with the system.

This section provides basic operating instructions. Before operating your system in a
production environment, refer to Hand Torch Setup on page 49 or Machine Torch Setup
on page 65.
Connect the electrical power, gas supply, and torch lead
For information on connecting the proper plug to the power cord, refer to Power Supply Setup on page 27.
Plug in the power cord and connect the gas supply line. For more information about the electrical requirements and the
gas supply requirements of the Powermax, see Power Supply Setup on page 27. To connect the torch, push the
FastConnect connector into the receptacle on the front of the power supply. You will attach the work lead in the next step.

CCC units do not ship with a power cord.
Torch lead
Work lead
Power cord (does not
ship with plug)
Gas supply line

Hypertherm Powermax125 Specifications

General

Brand	Hypertherm
Model	Powermax125
Category	Welding System
Language	English