58 Powermax125 Operator Manual 808080 Revision 0
5 – Hand Cutting
3. Drag the torch tip lightly across the workpiece to proceed with the cut. Maintain a steady, even pace.
Pierce a workpiece
1. With the ground clamp attached to the workpiece, hold the torch at an approximate 30° angle to the workpiece with
the torch tip within 1.5 mm (1/16 inch) of the workpiece before firing the torch.
WARNING!
SPARKS AND HOT METAL CAN INJURE EYES AND BURN SKIN
When firing the torch at an angle, sparks and hot metal will spray out from the nozzle. Point the torch
away from yourself and others. Always wear proper protective equipment including gloves and eye
protection.
To Next Page
Loading...
Need help?
General
