IBM 5100 Maintenance Analysis Procedures

(
(
(
(
(
(
5103 PRINTER MAP
PAGE 1 OF 2
ENTRY
POINTS
FROM
ENTER THIS MAP
MAP
ENTRY PAGE
STEP
NUMBER POINT
NUMBER
NUMBER
0200 A
001
001
(Entry Point A)
This is the entry MAP for the 5103 printer.
Is the PROCESS CHECK light on7
Y N
2
002
Note: if there is an auxiliary tape attached,
disconnect the auxiliary tape and disconnect
the printer. Connect the printer directly
to the
5100. The PROCESS CHECK light might turn
on. Press RESTART.
Wait 10 seconds.
Use the keys on the numeric section
of the
keyboard:
-Hold CMD and press HOLD
-Hold CMD and press - (minus)
-For
BASIC, hold CMD and press * (multiply)
-For
APL, hold CMD and press x (multiply)
-Press C
-Hold CMD and press 1
-Press EXECUTE
Follow the instructions on the display until
DCP2 MENU appears. Then:
-Enter 800
-Press EXECUTE
The 5103 printer
MDI should now load and
run. Follow the instructions on the display.
When completed, return to the BASIC/ APL
mode by pressing RESTART.
COPYRIGHT IBM
CORP 1975
EXIT POINTS
EXIT THIS MAP TO
PAGE
NUMBER
2
STEP
NUMBER
004
MAP
NUMBER
0420
01MAR76
MAP 081(H '
ENTRY
POINT
A
PN 1608393
EC 829580 PEC 828851
A MAP 0810-1
•
'.
: ==

IBM 5100 Specifications

General

Brand	IBM
Model	5100
Category	Laptop
Language	English