d. Moving one power supply at a time, swing the unit handle up and into its fully closed position on
the release latch.
Optional: Install disk drives in the preinstalled 5887 disk drive
enclosure
Learn about the disk drives and details on how to install them.
To install disk drives, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Remove the drive from the static-protective package.
Attention: Drives are fragile. Handle with care.
3. With the handle in the unlocked position, support the bottom of the disk drive as you align it with
the guide rails in the disk drive enclosure. For an example, see Figure 34 on page 33.
Figure 33. Closing the power supply release handle
32 Power Systems: Installing the 5887 disk drive enclosure
To Next Page
Loading...
Need help?
General