9. While you hold the rail bracket in place, carefully expand the rail until the other end reaches the
opposite rack flange.
10. Seat the pins of the opposite rail bracket in the marked mounting holes.
11. At the rear of the rail, close the rear hinge bracket to secure the rail to the rack cabinet flange.
12. Install one M5 screw in the open hole in the bracket between the two alignment pins (C).
13. Repeat steps 6 on page5-12fortheother rail.
Installing the 5887 disk drive enclosure into the rack
Learn how to install the 5887 disk drive enclosure into the rack. In addition to related safety information,
illustrations of the related hardware components are provided.
Important: Two people are required to safely lift the enclosure. Using fewer than two people to lift the
enclosure can result in injury.
To install the disk drive enclosure into the rack, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Remove the left side cover (A) and right cover (B) to show the mounting brackets.
3. Pinch the release to rotate the cover up and off from the chassis flange as shown in Figure 7 on page
8.
Figure 6. Securing the rail to the rack
Installing the 5887 disk drive enclosure or setting up a preinstalled 5887 disk drive enclosure 7
To Next Page
Loading...
Need help?
General