Print Language
PRINT LANGUAGE specifies the set of print languages used by the printer. Refer
to the previous page for print language menus.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and OCR
B are the only available values for this print quality. If a different print quality
value is desired, the print language must be changed first.
Print Character Table
PRINT CHARACTER TABLE prints out a table of the 3270 interface current
character set.
Character sets are shown in the 6500 Coax/Twinax Programmer’s Reference Manual
Active Print Language
Selects which group of print language sets (standard or alternate) will be active.
v Standard Print Language (the default)
v Alternate Print Language
Early Print Complete
Early print complete allows the printer to indicate to the host that print has
completed before it actually occurs. This can improve throughput in certain modes.
v Disable (the default). The printer will not respond until printing is complete.
v Enable. The printer will indicate to the host that is is able to accept more data
before printing is complete.
Note:
Early Print Complete should only be enabled to improve performance when
running DSC (LU0) or DSE (LU3). This does not apply in SNA (LU1) mode.
Interventions such as forms jams and end of forms will not be sent to the
host when Early Print Complete is enabled.
Hex Transparent Control
You can enable additional features that are not available in standard IBM
emulations. To access these features, send lead-in character text commands in the
data stream. You can also use ASCII codes X'80' through X'9F' as control codes if
configured to do so.
Chapter 4. The Configuration Menus 99
To Next Page
Loading...
Need help?
General