Graphics Option
Slashed Zero:
v Disable (the default). Prints zeros without a slash (0).
v Enable. Prints zeros with a slash (Ø) to distinguish zeros from the alphabetical
capital “O”.
Ignore
Dots Value:
v Disable (the default).
v Enable. Causes the Code V to expect position values to be specified in only 1/10
of an inch. If the dot position is also given, it is treated as text.
Append
Rotated:
v Disable (the default). Appends logos to an alphanumeric string rotated in a
clockwise, counterclockwise, or inverted orientation.
v Enable. When enabled, the logo is treated as a separate element.
Truncate
Off Page Alpha: When enabled, this parameter prevents the printing of
Error 48 (Element Off Page Error) if alphanumeric data, including spaces, extends
beyond the right side of the form.
v Enable (the default).
v Disable
True
Vertical 1/10: Determines if a vertical 1/10 of an inch parameter is used as
1/10 of an inch (Enabled) or as 7/72 of an inch (Disabled). When used as 1/10 of
an inch, rounding will occur to the nearest 1/72 of an inch. This can cause vertical
moves that have the same value to differ by _1/72 of an inch. When used as 7/72
of an inch, the absolute move is slightly smaller than expected. For example, a one
inch move would be 70/72 of an inch. Vertical moves that have the same value
will be identical in length.
v Disable (the default).
v Enable
Absorb
at ^PY:
v Absorb Motion (the default). Prevents paper motion following a system
terminator in a graphics (cc)PY command.
v Absorb All. When absorb all is selected, the system ignores all the data and
terminator until a host generated terminator is detected.
v Disable. When disabled, system terminators following a graphics command are
sent to the printer and result in paper motion.
Chapter 4. The Configuration Menus 171
To Next Page
Loading...
Need help?
General