UPC Descenders: This parameter determines if a gap is left for human readable
data in UPC/EAN bar codes, even if there is no human readable data. There will
be no change if there is human readable data.
v Enable (the default). Leaves a gap even if there is no human readable data.
v Disable. Does not leave a gap if there is no human readable data.
Rotate
Character Size: The Rotated Character Size option determines if rotated
(clockwise/counter-clockwise), expanded characters have a different size than a
non-rotated character with the same size parameters (Adjusted) or the same size
(Not Adjusted).
v Adjusted (the default).
v Not Adjusted
Ignore
Spaces:
v Disable (the default). Trailing spaces are NOT deleted from alphanumeric
elements in a graphics pass.
v Enable. Trailing spaces are deleted from alphanumeric elements in a graphics
pass.
Midline
PY:
v Enable (the default). Allows printable characters to precede the ^PY command.
v Disable. Requires the ^PY command to be the first characters on a line.
Dark
Barcode:
v Disable (the default). Bar codes are printed in normal mode.
v Enable. When enabled, prints all bar codes in a dark mode.
Expanded
Font:
v Block (the default). These are block characters compatible with the IGP-X00
printers.
v Scalable. These expanded characters have rounded edges.
LP+
Font:
v Disable (the default). The IGP/VGL uses its default half-dot font, which is
slightly different from the standard bitmap font used by LP+ at 12, 13, 15 and 17
cpi.
v Enable. The IGP/VGL uses the same font as used by LP+ at all cpi.
172 Infoprint 6500 User’s Manual
To Next Page
Loading...
Need help?
General