PTR Setup Option
This option selects the Special Function Control Code (SFCC) for the PTR_SETUP
command and functions. The selections for this process are given below.
Setup Parse
This selection is used to enable or disable the PTR Setup Option.
v Disable (the default)
v Enable
v Ignore
Setup SFCC
Sets the legal hex values from X'01' through X'FF'. These represent the ASCII code
(in hexadecimal) of the character used as the SFCC.
v X'21'h (the default). Corresponds to the “1” character.
v X'1' — X'FF'
File System
Provides the means for listing, viewing, and manipulating files in flash memory.
The following selections are available.
v Overwrite. This selection controls whether the files in flash memory can be
overwritten. With the default selection of Enable, files are overwritten. If the
selection is disabled, the files can not be overwritten.
v View Files. This selection provides a list of files in flash memory. Pressing the
Scroll↓ key allows you to view the file size.
v Delete Files. This selection provides a list of files in flash memory. Pressing the
Enter key will delete the displayed file from flash memory.
v Flash Avail. This selection provides a list of available files in flash memory.
v Optimize & Reboot. Pressing the Enter key with this selection displayed will
reclaim flash memory space and reboot the printer.
IMPORTANT:
Do not turn the printer off until it has completed the reboot and
is either Ready or Not Ready.
v Print File List. Pressing the Enter key with this selection displayed will cause
the printer to print a summary of files stored in flash memory. Statistics on file
system usage are also printed.
Chapter 4. The Configuration Menus 61
To Next Page
Loading...
Need help?
General