Define LF Code (Line Feed)
This parameter forces the printer to insert an automatic Carriage Return code into
the data stream whenever a Line Feed code occurs. This can be used in most
installations, but it is required if the host computer does not send Carriage Returns
to the printer.
v LF = LF (the default). Does not perform an automatic carriage return. The next
print position will be the current print position of the next line.
v LF = CR + LF. Performs an automatic carriage return. The next print position
will be print position 1 of the next line.
Auto LF
This parameter determines if text will wrap to the next line when the line of text
exceeds the right margin.
v Disable (the default). Truncates the text beyond the right margin until a CR or
CR + LF is received.
v Enable. Automatically inserts a CR + LF after a full print line.
IGP SFCC
You can specify which hex code (X'1' - X'FF') will be used as the Special Function
Control Character (SFCC). The SFCC denotes that the following data is an IGP
command.
v X'7E' (factory default)
v X'1' - X'FF'
PI Slew Range
You can specify how many lines the paper will feed.
v 16 (the default). A paper slew of 0-15 will move 1-16 lines.
v 15. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will move 1
line.
CR Edit
This parameter determines if a carriage return will be followed by a line feed.
v Disable (the default). The printer ignores all carriage returns that are not
followed by line feeds.
v Enable. The printer processes all carriage returns, even for those that are not
followed by line feeds.
Select Set
v Disable (the default). Uses the character set selected in the Select Font menu.
v UTF-8. Selects the UTF-8 character set (Unicode encoded font).
Chapter 4. The Configuration Menus 163
To Next Page
Loading...
Need help?
General