IBM AS/400 Repair And Parts

Card Enclosure
1 Power off the system. See Powering Off
the System in Chapter 3, "Service Refer-
enced Procedu res"
on page 3-1.
2 Disconnect the power cord.
3 Remove the covers. See "Covers" on
page 1-10.
4 Remove the access plate. See "Access
Plate"
on page 1-2.
5 Label or write down each card and the slot
where it is located.
6 Remove all of the cards in the card enclo-
sure. See "Cards"
on page 1-4.
7 Disconnect the cable or cables connected
to the card enclosure. You may need to
1-6 AS/400 940219404 Models 2xx Repair and Parts
remove some disk units to access the
cables. See "Disk Unit"
on page 1-12 (start
with step 2).
8 Loosen the screws rJ. You may need to
remove some disk units to access the
screws. See "Disk Unit"
on page 1-12
(start with step 2).
9 Remove the screws iii.
1 0 Slide the card enclosure out of the rear of
the frame.
11 Remove the screws Ii to disassemble the
card enclosure.
12 Install the card enclosure by reversing the
removal procedure.
Ensure that the cards are installed
in the
same slots where they were originally
located.
This ends the procedure.

IBM AS/400 Specifications

General

Brand	IBM
Model	AS/400
Category	Network Hardware
Language	English