Table 41. 4-mm Data Cartridges (continued)
IBM Part Number Type of Cartridge Native (uncompressed) Capacity
59H3465 Data Cartridge DDS3 12 GB
59H4458 Data Cartridge DDS4 20 GB
Most bulk eraser devices do not have the capability to erase the 4mm data cartridge. To correctly erase a
4mm data cartridge with a bulk eraser device, the erasure coercivity rating must be a minimum of 3900
Oersted.
Resetting the tape drive
You might need to reset your tape drive. Use the procedure in this topic to perform this task.
Use this information to reset your tape drive, without affecting server operation. Allow up to 2 minutes
for the entire tape drive process to complete.
Attention: Resetting a tape drive before the current backup operation has completed can cause loss of
customer data.
To reset the tape drive, complete the following steps:
1. Press and hold the eject button for 20 seconds, and then release the button. The LEDs on the drive
flash while the reset function is in process.
2. After the LEDs stop flashing, wait approximately one minute for the drive to complete the reset
operation. The drive is then ready to use.
80/160 GB DAT160 SAS tape drive (FC 5619)
Learn about the features of this media device.
For FC 5619, one of the following feature codes must be ordered to internally attach the tape drive:
v FC 3655 SAS cable group (logic and power) for HH SAS tape in 3.5" DASD backplane. The 3.5" DASD,
uses the short cable with part number: 42R5814 (optional 42R5815)
v FC 3656 SAS cable group (logic and power) for HH SAS tape in SFF DASD backplane. The 2.5" DASD,
uses a longer cable with part number: 46K5450 (replaces 42R5815)
Managing devices 53
To Next Page
Loading...
Need help?
General