2. Touch the static-protective package that contains the memory module to any
unpainted metal surface on the outside of the canister.
3. Remove the memory module from the package.
4. Turn the memory module so that the keys align correctly with the connector.
5. Insert the memory module into the connector by aligning the edges of the
module with the slots at the ends of the connector (see Figure 23).
6. Firmly press the memory module straight down into the connector by applying
pressure on both ends of the module simultaneously. The retaining clips snap
into the locked position when the module is firmly seated in the connector.
Note: If you can see a gap between the module and the retaining clips, the
module has not been correctly inserted. Open the retaining clips, remove the
module, and then reinsert it.
Figure 23. Installing memory module option
Chapter 2. Installing the hardware 37
To Next Page
Loading...
Need help?
General