b. Connect the USB flash drive to the Storwize system and allow it to
initialize.
c. Connect the USB flash drive to the computer to check that the initialization
completed.
9. If the system initialization completed successfully, click Finish. If you have a
network connection to the Storwize system, the system management GUI is
displayed. If the computer does not have a network connection to the
Storwize system, go to the computer that you will use to manage the system
and start a supported browser. Direct the browser to the management address
you specified for the system.
10. Log in with user name superuser and password passw0rd.
Note: The 0 character in the password is a zero, not the letter O.
11. Follow the on-screen instructions to begin setting up your system.
Note: The other options that are available in the initialization tool are used to
recover the service IP address or the superuser password.
Configuring a Storwize V3700 system to be NEBS compliant
For operation in Network Equipment-Building System (NEBS) compliant
installations, the Storwize V3700 system can be configured to extend its operational
temperature range to meet NEBS operating temperature requirements.
Note: The Storwize V3700 system might not be able to save its cache and state
data if the power fails while it is operating within the extended temperature range.
This is because the battery capacity decreases as temperature rises. If the save of
cache and state data cannot be completed, an extended service action is required to
recover the system and data might be lost. Keep the temperature within the
normal operating range if possible, and maintain a reliable power supply.
v To extend the operational temperature range of all enclosures in the system to
meet NEBS operating temperature requirements, enter the following CLI
command:
chsystem -hightempmode on
Once set, high_temp_mode will be be applied to all enclosures in the system.
v To configure the default operating temperature ranges, enter the following CLI
command:
chsystem -hightempmode off
v To determine which mode is currently configured, read the value of the
high_temp_mode parameter in the lssystem output.
Note: Configuring the Storwize V3700 system to be NEBS compliant only changes
the way the system responds to raised temperature. You must also ensure that the
way the system is racked, and the operating environment, conforms to NEBS
requirements. (See “NEBS compliant earth connection” on page 19.)
Adding an expansion enclosure to an existing system
When you add an expansion enclosure to an existing system, you must use the
Storwize management GUI to update the system configuration.
62 Storwize V3700: Quick Installation Guide
To Next Page
Loading...
Need help?
General