Chapter 6. Volume configuration 327
6.7 Mapping Volumes to Host after volume creation
Newly created volume can be mapped to the host at creation time, or later. If the volume was
not mapped to a host during creation, then to map it to a host, follow the steps in 6.7.1,
“Mapping newly created volumes to the host using the wizard” on page 327.
6.7.1 Mapping newly created volumes to the host using the wizard
This section involves continue to map the volume that was created in 6.3, “Creating volumes
using the Volume Creation” on page 303. We assume that you followed that procedure and
are on the Volumes pane showing list of volumes as shown in Figure 6-43.
Figure 6-43 Volume list
To Next Page
Loading...
Need help?
General