Returning a device or component
If you are instructed to return a device or component, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Removing and replacing server components
This section provides information for removing and replacing components in the
server.
Removing and replacing consumable and structural parts
Replacement of consumable and structural parts is your responsibility. If IBM
installs a consumable and structural part at your request, you will be charged for
the installation.
The illustrations in this document might differ slightly from your hardware.
Removing the cover
Use this information to remove the cover.
About this task
To remove the server cover, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 122.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
3. If the server has been installed in a rack, slide the server out from the rack
enclosure.
4. Remember to check if the cover is locked. If it is locked, unlock the cover first.
Latch
Lock
Unlock
Figure 33. Unlocking cover
126 IBM System x3550 M5 Type 5463: Installation and Service Guide
To Next Page
Loading...
Need help?
General