SAS/SATA
power cable
13. If you removed any fans, install them.
14. Insert the hard disk drives and the fillers the rest of the way into the bays.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 135.
Installing a SAS/SATA 8 Pac HDD with a ServeRAID adapter option
If the server is a 16-drive-capable model with eight hard disk drive bays installed,
you can install an IBM System x3650 M4 Hot-swap SAS/SATA 8 Pac HDD with a
ServeRAID adapter option. See http://www.ibm.com/servers/eserver/serverproven/
compat/us/ for a list of supported optional devices. To order a SAS/SATA 8 Pac
HDD with a ServeRAID adapter option, contact your IBM marketing representative
or authorized reseller.
The SAS/SATA 8 Pac HDD with a ServeRAID adapter option kit contains the
following components:
v Eight blank EMC fillers
v Two SAS signal cables
v One configuration cable
v One internal power cable
v One 2.5-inch hard disk drive backplane
v One RAID adapter (part number 00D7082 or 46M0912)
Chapter 2. Installing optional devices 73
To Next Page
Loading...
Need help?
General