Chapter 2. Installing options
Important: Before you install optional hardware, make sure that the server is
working correctly. Start the server, and make sure that the operating system starts,
if an operating system is installed, or that a 19990305 error code is displayed,
indicating that an operating system was not found but the server is otherwise
working correctly. If the server is not working correctly, see the Problem
Determination and Service Guide for diagnostic information.
This chapter provides detailed instructions for installing optional hardware devices in
the server.
Server components
The following illustration shows the major components in the server (depending on
the server model). The illustrations in this document might differ slightly from your
hardware.
Bezel
Control panel assembly
USB cable assembly
SAS/SATA
backplane
S ATA
backplate
Fan
assembly
Hot-swap fan
Hot-swap power supply
Fixed power supply
Hot-swap power supply filler
Power supply cage
Hot-swap
drive
Hot-swap
drive trim piece
Simple-swap
drive
Simple-swap
drive trim piece
DVD
drive
DVD drive
trim piece
Processor baffle
ServeRAID 8k-1
VRM
Heatsink
Microprocessor
System board
Heat sink
retention bracket
Cover
Heat sink
filler
DIMMs
Drive bay EMC shield
Hard disk drive
EMC shield
DIMM air duct
Rear adapter retention bracket
© Copyright IBM Corp. 2008 17
To Next Page
Loading...
Need help?
General