the battery. This might take a few minutes, after which the startup process
continues. This is a one-time occurrence.
Important: You must allow the initialization process to be completed. If you do
not, the battery pack will not work, and the server might not start.
The battery comes partially charged, at 30% or less of capacity. Run the server
for 4 to 6 hours to fully charge the controller battery. The LED just above the
battery on the controller remains lit until the battery is fully charged.
Until the battery is fully charged, the controller firmware sets the controller
cache to write-through mode; after the battery is fully charged, the controller
firmware re-enables write-back mode.
2. When you restart the server, you are given the opportunity to import the
existing RAID configuration to the new ServeRAID SAS controller.
Installing an optional ServeRAID adapter advanced feature key
About this task
To install an optional ServeRAID adapter advanced feature key, complete the
following steps:
Procedure
1. Read the safety information that begins on page “Safety” on page v and
“Installation guidelines” on page 37.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see “Turning off the server” on page 23).
3. Remove the cover (see “Removing the cover” on page 45).
4. Align the upgrade key with the connector on the ServeRAID adapter and push
it into the connector until it is firmly seated.
Chapter 2. Installing optional devices 137
To Next Page
Loading...
Need help?
General