controller. If you disable a device, it cannot be configured, and the operating
system will not be able to detect it (this is equivalent to disconnecting the
device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Operating Modes
Select this choice to view or change the operating profile (for example,
performance and power utilization).
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable the UEFI to interact with PCI mass
storage devices that are not UEFI-compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Disabled is the default.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address; specify
whether to use the static IP address or have DHCP assign the IMM IP
address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
- Reset IMM
Select this choice to reset IMM.
– Adapters and UEFI Drivers
Select this choice to view information about the adapters and drivers in the
server that are compliant with EFI 1.10 and UEFI 2.0.
v Network
160 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide
To Next Page
Loading...
Need help?
General