9
MEMORY OPERATION
9-3
D Selecting in the MEMORY screen
1. Open the MEMORY screen.
»
MEMORY
2. Select the desired memory channel by rotating
and then pushing
.
(Example: memory channel 2)
Memory channel 2 is selected
D Entering in the VFO mode
[Example: Entering 7.088 MHz, LSB, into memory
channel 2]
1. Push
to select the VFO mode.
• “VFO A” or “VFO B” is displayed.
2. Set the frequency, operating mode and filter.
3. Push
or
to select the channel to enter.
• “BLANK” is displayed if the selected channel has no
contents.
L If the selected channel was previously entered,
the contents will be overwritten.
4. Touch the channel number.
L You cannot touch the channel number when the Mini
scope screen or expanded screen is displayed.
• The VFO/MEMORY screen is displayed.
5. Touch [MW] for 1 second to save the entered
contents into the selected channel.
• “BLANK” disappears or the selected channel’s
contents are overwritten.
Memory channel selection (Continue)
You can enter memory channel contents in either the VFO mode or the Memory mode.
Entering memory channel contents
D Entering in the Memory mode
[Example: Entering 21.280 MHz, USB, into memory
channel 3]
1. Push
to select the Memory mode.
2. Push
or
to select the channel to enter.
• “BLANK” is displayed if the selected memory channel
has no contents.
L If the selected channel is previously entered, the
contents will be overwritten.
3. Set the desired frequency, operating mode, and
filter. (p. 3-3)
4. Touch the channel number.
• The VFO/MEMORY screen is displayed.
5. Touch [MW] for 1 second to save the entered
contents into the selected channel.
• “BLANK” disappears or the selected channel’s
contents are overwritten.
Rotate
Push
To Next Page
Loading...
Need help?
General
